■ Electrical Characteristics Ta = 25℃(VCC = 5.0 V, VEE = Gnd, TA = 25℃, unless otherwise noted.) Parameter Symbol Testconditons Min Typ Max Unit VCC = 5.0 V to 30 V, VIC = 0 V to VCC -1.7V VO 1.4 V, RS = 0Ω TA = 25℃ TA = Thigh *5 9.0 TA = Tlow *5 9.0 Average Temperature Coefficient of Input Offset Voltage △VIO/△T TA = Thigh to Tlow *5 7.0 μV/℃ 5.0 50 150 TA = Thigh to Tlow *5 -45 -250 -50 -500 Average Temperature Coefficient of Input Offset Current △VIO/△T TA = Thigh to Tlow*5 10 pA/℃ VCC = 30 V 0 28.3 VCC = 30 V, TA = Thigh to Tlow 0 28 Differential Input Voltage Range VIDR VCC V RL = 2.0 kΩ VCC = 15 V, For Large VO Swing, 25 100 TA = Thigh to Tlow 15 Channel Separation CS 1.0 kHz ≤ f ≤ 20 kHz, Input Referenced -120 dB Common Mode Rejection CMR RS ≤ 10 KΩ 65 70 dB Power Supply Rejection PSR 65 100 dB TA = Thigh to Tlow *5 VCC = 5.0 V, RL = 2.0KΩ TA = 25℃ 3.3 3.5 VCC = 30 V, RL = 2.0 KΩ 26 VCC = 30 V, RL = 10 KΩ 27 28 VCC = 5.0 V, RL = 10 KΩ TA = Thigh to Tlow *5 Output Source Current IO+ VID = +1.0 V, VCC = 15 V 20 40 mA VID = -1.0 V, VCC = 15 V 10 20 mA VID = -1.0 V, VO = 200 mV 12 50 μA Output Short Circuit to Ground *7 ISC 40 60 mA TA = Thigh to Tlow *5 VCC = 30 V, VO = 0 V, RL = ∞ 1.5 3.0 VCC = 5 V, VO = 0 V, RL = ∞ 0.7 1.2 *5 Tlow = 0℃, Thigh = +70℃ *6 The input common mode voltage or either input signal voltage should not be allowed to go negative by more than 0.3 V. The upper end of the common mode voltage range is VCC -1.7 V. *7 Short circuits from the output to VCC can cause excessive heating and eventual destruction. Destructive dissipation can result from simultaneous shorts on all amplifiers. Input Offset Voltage VIO mV IIO 2.0 7.0 IIB nA V/mV AVOL VICR TA = Thigh to Tlow *5 V Large Signal Open Loop Voltage Gain Input Offset Current Input Bias Current Input Common Mode Voltage Range *6 VOH Output Voltage-High Limit Output Voltage-Low Limit VOL V Power Supply Current (Total Device) ICC mA 5 20 mV IO- Output Sink Current LM358 ■ Marking Marking LM358 http://www.luguang.cn mail:lge@luguang.cn